Custom Query (3366 matches)


Show under each result:

Results (67 - 69 of 3366)

Ticket Resolution Summary Owner Reporter
#84 fixed Wrong no of atmos prognostic fields lois hanneke


I have a global run (to get LBC files for my LAM runs) that crashes with this error:

OPEN: File /hpcx/devt/n02/n02-ncas/hanneke/globaldumps/sep02/2002090306.T+3 to be Opened on Unit 21 Exists

Mismatch in no of prognostic fields. No of prog fields in Atmos dump 750 No of prog fields expected 776

Run RECONFIGURATION to get correct no of prognostic fields in atmos dump or Check/Reset? experiment in User Interface

Failure in call to INITDUMP * UM ERROR (Model aborting) : Routine generating error: INITIAL Error code: 102 Error message:

INITDUMP: Wrong no of atmos prognostic fields


I had a look through old tickets and did find one with a similar problem:

I am using a global dump however, that I got from Chang. It does have less variables than other global dumps I have used. I have done a reconfiguration on this global dump to get a start dump for the LAM run and this worked fine. But how can I get the boundary conditions from this start dump?

Thanks for your help! Hanneke

#85 fixed Reconfiguration fails at call to control lois umdoc

Dear UMSUPPORT, I have for some time been trying to get an experiment to run on the hpcx. I currently have the results of two attempts on the hpcx. The runs are in ~richie/umui_runs/ and are named xcocd and xcpxc the output (leave files) have been copied to this directory too.

xcpxc tries to read in a binary file with ecmwf data in it by convincing the UM it is a grib file. I realise this is somewhat unusual but it worked on newton. The mod for this bit is um_mods/vn4.5/recon_grads.mod

xcocd uses a start dump from a run on newton.

Both runs are at 432 * 325 horizontally and use VN4.5. With liberal use of print statements I have found that the problem occurs when moving from scontrol to control (in the case xcpxc this is after the grib/binary has been read.)

I am hoping that there is a very obvious error I have made moving from newton to hpcx and if you could help to find it I would be very grateful. Cheers, Richard

Richard Ellis. Centre for Ecology and Hydrology, Room 63, Mclean Building, Crowmarsh Gifford, Wallingford, Oxfordshire, OX10 8BB, UK. Tel: 01491 692571

#86 fixed TRIFFID "disturbance" ancillary file um_support t.m.osborne@…


I am trying to run UM vn4.5 with MOSES 2 and TRIFFID. I believe I have all the mods with the model code, but I do not have an "disrurbance" ancillary file. Any ideas where (from whom) I may be able to get one that works on HPCx?



Note: See TracQuery for help on using queries.